Making the First Mould! - Group C MR-2 Build Ep: 02

In this episode we'll finally make a start on the physical build, focusing on removing the panels from the car to give us a clean starting point, as well as setting up the 3D printers to enable us to make the moulds for this project. Huge thank you to High Performance Academy for providing affiliate links for their courses! Every course you sign up for after clicking any of the links below will give me a small kickback and help directly support my builds. I encourage you to check them out: https://hpcdmy.co/Tofu https://hpcdmy.co/TofuCourses https://hpcdmy.co/TofuCAD Be sure to use the coupon code: "TOFU75" for $75 off at checkout! Thanks again to Stan for his help once again with the CAD and 3D scanning work that went into this project. Check him out on Instagram and YouTube: www.instagram.com/stanscustomcreations/ www.youtube.com/@SCCDesignLab The printers in this video were provided by Elegoo, thank you to them for their support. Check out their product at the link below: https://elegoo.com/collections/3d-printing Enjoy the video. If you enjoy these videos and want to see more, please consider supporting me on Patreon. I would love to be able to work on builds like these full time and your support helps make that possible. There are heaps of special rewards and behind the scenes posts so please check it out. https://www.patreon.com/TofuAutoWorks Also feel free to checkout my Instagram where I post regular updates on all of my builds. https://www.instagram.com/tofuautoworks/ Timestamps: 00:00 - Intro 00:16 - 3D Prints and Timelapse 05:42 - Mirroring the prints 08:09 - Finishing the 3D prints 10:46 - Organizing the garage 12:53 - The first rolls of sandpaper in the new shop 15:24 - Processing the prints 19:25 - Assembling the outer mould sections 34:08 - Assembling the inner mould section 41:55 - Joining the two halves 49:40 - Completed mould 50:46 - Outro