Starting on the Rear Lip! Sky-gea build: Part 32

Finally on to the very last piece of this widebody GTR conversion, the rear lip to tie the full kit together. For this project I once again roped in my mate Stan who has helped out with a lot of the CAD for this project and designed and built this first prototype rear lip entirely in CAD then reproduced in fiberglass. Check out Stan on Instagram https://www.instagram.com/stanscustomcreations/ Huge thank you to High Performance Academy for providing affiliate links for their courses! Every course you sign up for after clicking any of the links below will give me a small kickback and help directly support my builds. I encourage you to check them out: hpcdmy.co/Tofu hpcdmy.co/TofuCourses hpcdmy.co/TofuCAD Be sure to use the coupon code: "TOFU50" for $50 off at checkout! Enjoy the video. If you enjoy these videos and want to see more, please consider supporting me on Patreon. I would love to be able to work on builds like these full time and your support helps make that possible. There are heaps of special rewards and behind the scenes posts so please check it out. https://www.patreon.com/TofuAutoWorks Also feel free to checkout my Instagram where I post regular updates on all of my builds. https://www.instagram.com/tofuautoworks/ Timestamps: 00:00 - Intro 00:15 - Removing the plugs 01:53 - Test fitting and trimming widebody 08:13 - Completed widebody 08:48 - 3D printed rear lip mould 10:31 - Removing tow bar for now 13:10 - Assembling the mould 16:18 - Filling layer lines and print seams 19:20 - Primer 22:16 - Sanding 24:32 - More sanding 25:10 - Polishing 26:23 - Capping off the ends 28:07 - Applying mould release 30:18 - Gelcoat 31:30 - Fiberglass 35:55 - Demoulding 37:40 - Trimming and sanding 39:25 - Test fitting 40:05 - B roll 40:33 - Outro