FSJT-N01 цифровой анемометр(скорость ветра) & FXJT-N01 флюгер(направление ветра) 26 февраля 2026 г.

https://devices.esphome.io/devices/renke-rs-fsjt-n01-wind-speed/ Renke RS-FSJT-N01 Wind speed anemometer General Notes The Renke RS-FSJT-N01 Wind speed anemometer is sold in four versions: RS485 digital ModBUS output 0-5V analog voltage output 0-10V analog voltage output 4-20mA analog current output RS-FSJT-N01 Wind speed anemometer Parameters: Measurement range: 0~30m/s, resolution 0.1m/s, accuracy ± 0.3m/s Starting wind speed: 0.5m/s DC power supply: 10~30V DC Configuration presented here is for the RS485 digital ModBUS version. Wiring The cable coming out through the bottom of the unit has the folling pinout: Brown: positive power supply Black: negative power supply and GND Green: RS485-A Blue: RS485-B ModBUS Parameters Wire up a an RS485 transceiver to an ESP32 to interface with the device using ESPHome's Modbus Component. Connection parameters: Baud Rate: 4800 (default), supports 2400 and 9600 Data bit length: 8 Parity check: None Stop bit: 1 Device address: 1 Register address for speed value: 0 Register data type: U_WORD, multiplied by 10 ==== https://devices.esphome.io/devices/renke-rs-fxjt-n01-wind-direction/ Renke RS-FXJT-N01 Wind direction meter General Notes The Renke RS-FXJT-N01 Wind direction meter is sold in four versions: RS485 digital ModBUS output 0-5V analog voltage output 0-10V analog voltage output 4-20mA analog current output RS-FXJT-N01 Wind direction meter Parameters: Measurement range: 8 directions DC power supply: 10~30V DC Note: there's an arrow on the base of the unit, make sure you point that to the North when fixing it to its final location. Configuration presented here is for the RS485 digital ModBUS version. Wiring The cable coming out through the bottom of the unit has the folling pinout: Brown: positive power supply Black: negative power supply and GND Green: RS485-A Blue: RS485-B ModBUS Parameters Wire up a an RS485 transceiver to an ESP32 to interface with the device using ESPHome's Modbus Component. Connection parameters: Baud Rate: 4800 (default), supports 2400 and 9600 Data bit length: 8 Parity check: None Stop bit: 1 Device address: 1 Register address for direction gear: 0 (values from 0 to 7, representing cardinals) Register address for direction value: 1 (valies from 0 to 360, representing degrees) Registers data type: U_WORD